Display your benchies with pride! You can put a bottom row, and even stack some on top.

(I might do a version with indents on top to align them, but that would weaken it, so I'm not too sure about that).

I spent WAY too much time (and filament) refining this, so if you like it, please give it a "like"."

There are 2 versions, a shorter one and a longer one, in case your wall isn't big enough or something.

You can print it with 0 top and bottom layers (see 3MF file) if you want a cool effect. I just did it in clear PLA, 0.2mm heights.

I recommend LOTS of perimeters, like 4+, for strength.

Check out my community here: https://www.reddit.com/r/honeycombwall/