Dyson V7 - V11 Drill Dust Collector - 180 Degrees Inverted
Copyright Claim
Dyson V7 - V11 Drill Dust Collector - 180 Degrees Inverted
Boost
40
103
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
3.1 h
1 plate
Boost
40
103
9
0
111
27
Released
Description
I really liked haitonno's design for this drill dust collector, but for some reason, it was "upside down" from what my Dyson would need. So, I flipped the button/lid around. Much better.
I printed in 0.3 resolution, and the button broke almost immediately - so probably print it in 0.2 to be safe.
Category: ToolsComment & Rating (9)
All
How can this work? Look at the model, there is no hole where the dyson can suck. It's sealed. You see it in the model. I was so stupid and just printed it, and saw it after.
This is not a joke is it?
3
Reply
you have to brake it.
remove wall in the middle
0
Reply
0.2 and the Button Broke
0
Reply
This design is non functinal.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Not sure if I did something wrong, but I didn't see the support in the middle which was tricky to clear. It worked a little, but wasn't able to capture all the mess. As a model though, its a great fit and looks the business. I'm going to keep using it even though it doesn't work perfectly.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Druck funktioniert nicht
0
Reply
Button failed
0
Reply
The print profile is no longer public
poor-.....
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld