Ender 3 Pro Front Main Board Enclosure
Copyright Claim
Ender 3 Pro Front Main Board Enclosure
Boost
10
5
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
10
5
7
2
8
5
Released
Description
This is a simple enclosure that flips the main board to the bottom of the enclosure so you don't have to flip the printer on its side to access the wiring. Uses all stock screws except for the 3 that hold the lid on. Works for any stock footprint board (4.2.2, 4.2.7, SKR E3).
Rev.1: Tightened up screw holes, made the wire pass thru wider, adjusted board position to make wiring easier.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
much nicer to have easier access to the board I thought it would come out really cool in Bambu translucent PETG
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
screw holes too big on my print, otherwise good.
The designer has replied
0
Reply
Are they way too big or just a little bit?
0
Reply
Replying to @minist3r
original screws slide in and out. they never caught on to anything. tried using the next screw size up but none of the standard sizes fit. they were all to big. I've never done a remix to anything so I don't know how to fix in the design.
0
Reply
Replying to @jturner7403
I'll upload a revised model in a few minutes.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld