Grip Extension for Omlet Walk In Run Lock (Griff Verlängerung für Schloss an Omlet Voliere)
Boost
2
0
0
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
12 min
1 plate
4x Grip Extension, 0.2mm layer, 3 walls, 15% infill
Designer
21 min
1 plate
Boost
2
0
0
0
3
1
Released
Description
The locks on our new Omlet Walk In Run were very fiddly to use so I designed and printed this little extension, which you can slide onto the short metal part of the lock to make it easier to grip.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.3 mm
Infill:
0%
Filament:GST3D PLA+ Fuchsia
Notes:
For a nicer finish, I printed the bottom with a concentric pattern. Also I advise you to crank up the wall count for a sturdy print.
Tinkercad :)
Category: PetsComment & Rating (0)
All
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld