This is my way to mount e3d Chimera hotend to original CTC (Replicator 1 clone) XY carriage. This design allows you to easy assemble/disassemble hotend in case of any issues or maintenance. From hardware, you will need some M3 screws to connect printed parts and 2-3 washers to adjust the distance to X endstop.
I am using older version of the desig and it works well for the last month. In near future I am planning to add special fan duct to this (the first sketch is included in rsdoc file).
In my setup I used china clone of e3d Chimera hotend. And becaude of this I had to drill thru bowder tube holder to put bowden tube inside chimera block without this it was almost unprintable.
Printer Brand:
MakerBot
Printer:
MakerBot Replicator 1
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
100
Notes:
I printed it with PLA with 0,2 mm layer height and works well. Support needed only for RightLeg.