Motorized Geared Easter Style Bunny by StanfordBB

StanfordBB

Art>Other Art Models

GIF

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

4.7 h

2 plates

4.8(4)

0.2mm layer, 2 walls, 15% infill

Designer

5.7 h

2 plates

5.0(2)

0.2mm layer, 2 walls, 15% infill

Designer

5.5 h

2 plates

5.0(1)

Open in Bambu Studio

Boost

Released

Description

The model should be printed on the same plate with rainbow gradient material, so it will look very easteryyyyy~

A motorized version is still under construction, will be released later.

Comment & Rating (11)

@GChannel

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed flawlessly. I used a Rainbow PLA for the main parts and PETG for the connectors. I’ll update with assembled pictures soon. I did tweak the settings from Tree Slim supports to Tree Organic. This added supports to Rabbit ears and a bit more around the center conector piece. All easily came off. I also forced outer brim on all pieces just in case. Excited to assemble!

The designer has replied

@GChannel

Replying to @GChannel :

Ok I *think* I put it together correctly. Adding pics of the sides that aren't shown clearly in the pictures above. I hope this helps others. It moves smoothly but to get it back to the "original state" I have to "unwind" in the opposite direction. I recommend printing connector pieces in PETG to allow for a little more flexibility if you need to adjust the pieces.

(Edited)

@STFBB

Nice work! I will also upload some picture at 360 angle

(Edited)

@till.kristoffer

Print Profile

0.2mm layer, 2 walls, 15% infill

Some assembly instructions would be nice but it is manageable to just look at the different angled pictures. Almost hypnotic to look at it the gear spins