Tumbler spice shaker- Stanley style
Copyright Claim
Tumbler spice shaker- Stanley style
Boost
30
34
14
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2 h
3 plates
Open in Bambu Studio
Boost
30
34
14
6
41
53
Released
Description
This is a spice shaker container for use with all spices. I've included salt and pepper lids. If any other spice lids are needed please comment and I'll make them and add it here.
You will need 1- 3mm x 6.25mm course flat top hex screw
NOTE: do not over tighten the swivel onto the lid. The lid needs to rotate freely but snug.
Comment & Rating (14)
All
Boosted
Great print with pla. Bigger than I expected too.
The designer has replied
1
Reply
thank you. please check out my other designs
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
easy print
The designer has replied
0
Reply
looks great. thank you for the rating
please check out my other designs
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thank you for the rating. please check out my other designs.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thank you for the rating. please check out my other designs
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thank you for the rating
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thank you for the rating
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thank you
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld