Guides for the Neptune 3 and Neptune 3 Pro magnetic print beds. Used to make it easier to attach the printbed after it has been removed.

Include a modified left guide in case you're using the attached Bobbylebob's scrap bin.

This is a remix of another printed guide, but with changed dimensions to accommodate the Pro model's automatic bed levelling notch. The original model had a problem in which this notch collided with the left guide.

These guides can also be used for the non-Pro model of Neptune 3, as guides are just smaller and require less material.

In my case, they were printed with regular PLA, but temperature-resistant PLA may be preferable in the long run as the guides contact the magnetic printbed.

Double-sided tape is used to attach the guides under the bed. The first photo shows where the guides are attached in case you're using the scrap bin.

“Printbed Guide (Right)” should be attached to the right corner;

“Printbed Guide (Left)” should be attached to the left corner (in case no scrap bin is used);

“Printbed Guide (Left, Bin)” should be attached to somewhere between the cable and right corner (in case scrap bin is used).