Minions Figure Miniatures
Remixed by
Copyright Claim
Minions Figure Miniatures
Remixed by
Boost
243
368
82
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
34 h
1 plate
0.16mm layer, 2 walls, 15% infill
Designer
45.7 h
1 plate
Open in Bambu Studio
Boost
243
368
82
15
1.4 k
591
Released
Description
i Love Minions so i must mix it for the bambu lab ams
best to print with tree support and 4 Colours
Thx @_Building_Arts_ for the great idea
I've improved the print bed adhesion for a perfect print
Comment & Rating (82)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
They were printed with a P1S with the AMS. Used a .4mm nozzle, a .2mm layer height, reduced the infill to 10%. I printed with Basic PLA. This was a great model!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
came out very good. cut it in parts and glued them
1
Reply
Great remix and a good test for me and my new 3d printer :)
1
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
excellent print! my wife loves minions so these are one of my first prints. very clean. couple spots in the model where the eye shows around the goggles, noticeable with Stuart. I also felt it used white too much. especially with Kevin.
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
co dodat prisluhovači nesmí chybět v žádné domacnosti
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
Great models. My students can't get enough of them.
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed well!
0
Reply
Excellent print.great model. 4mm nozzle, 0,16mm layer height.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I printed all three on the same plate, unfortunately without purge tower. Therefore the print quality suffered somehow. The models are great though, love them!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Easy print, Supports abit hard to remove
0
Reply
Related Models
© 2024 MakerWorld