They were printed with a P1S with the AMS. Used a .4mm nozzle, a .2mm layer height, reduced the infill to 10%. I printed with Basic PLA. This was a great model!

came out very good. cut it in parts and glued them

Great remix and a good test for me and my new 3d printer :)

just what I was lokking for, thanks. Scaled down to 40%.

bellissimi

love the design , i hope there was a better settings for the supports as they left a bit of defect uder the eyes

Only made one of the designs, but printed well just the same.

These came out amazing! Great model!

excellent print! my wife loves minions so these are one of my first prints. very clean. couple spots in the model where the eye shows around the goggles, noticeable with Stuart. I also felt it used white too much. especially with Kevin.

co dodat prisluhovači nesmí chybět v žádné domacnosti