This design is for everyone who have the older Sapphire versions without an access door for the cable management or, like me, installed a cable chain and realized the cables are too short....
Here the cable chain mounts I designed as well: https://www.thingiverse.com/thing:4736894

It mounts at the frame using M4 screws with hammer nuts. It lets about 4 mm space on the left as I need the space for my enclosure parts later. If this bothers you you can extrude the side to fit the frame perfectly or scale up to 40mm.

The lister terminal and the lid is screwed with M2 screws. For the lister terminal there is also a hole to fit a nut. For the lid I didn´t design threads as I felt it fits perfectly without it.

Would be great if you could give me feedback in the comments, a like and post a make if you did this.

Sapphire Plus

No

20%