Cute Easter Egg Hunt Trophy
Designed with Nomad sculpt
Basic Print settings I used are: .20 layer height, Walls Arachne, Thick Bridges(checked), 10% gyroid infill with Infill Combination(checked) and Internal solid infill pattern rectilinear, top surface pattern > concentric.
Support settings i used are: Tree(auto)>Tree Organic> Threshold angle 30> On build plate only (checked) > Remove small overhangs(checked)
*feel free to experiment with supports you may find some better settings*
Supports are kind of tough on bottom of cup piece but i find if you use your cutters and cut right where supports meet model they usually seperate pretty easily, yo may need to go over with a deburring tool after as bottom will be a bit rough but a little patience will make it look ok.