Uh1 Front Protection
Copyright Claim
Uh1 Front Protection
Boost
1
2
2
Print Profile(1)
0.2mm layer, 2 walls, 30% infill or more
Designer
28 min
1 plate
Open in Bambu Studio
Boost
1
2
2
0
5
2
Released
Description
Protection for your uh1
recommendations for the print :
-use support only for the middle part were the glass(protection) will sit.
-use more then 20% infil for resistance
-use abs/asa/cf
This model has holes for grub screws, one at the top and two at the bottom. the upper one is M3x3mm and the lower ones M3x5mm.
I generally create parts for my airsoft guns but also parts for different cars
This is my first upload on the platform, if you could leave a like and a comm I would appreciate it very much. :3
thank you very much! <3
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 30% infill or more
Quality is great, didn’t fit my UH1 though… although I’m pretty sure it’s my own user error.. haha
The designer has replied
0
Reply
ensure that the printer is within the parameters. the model is very fixed to distribute the impact energy better. important to point out is that it is made for a replica of uh-1, the sizes may be different from one manufacturer to another
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld