So I made some keycaps for my 65% Keyboard, which has a qwertz layout so in case somebody wants a qwerty just tell me.

This print really tests your bed adhesion and stringing. If your settings are not dialled in it probably is not going to fit.

In case there is some striging in the stems i recommend a blow torch just for a second. I printed in PLA but tested with other materials, but surprisingly PLA felt best.

It is quite a bit lower than standard CherryMX caps and all of them are the same height, which i liked best.

Included are all necessary sizes unlabled

• 1u
• 1.25u
• 1.5u
• 1.75u
• 2u
• 2.25u
• 6.25u

All the alphanumeric keys are marked and everything should work.

The fuzzy skin is recommended because it makes the outside look better and also it provides better adhesion to the stems.