Canopy whoop (Mobula 8)

Remixed by

Canopy whoop (Mobula 8)

Remixed by
Boost
15
21
12

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
5.0(1)

Open in Bambu Studio
Boost
15
21
12
2
94
38
Released

Description

I liked the canopy shared by Bacon2002 but there where small “improvements” I made to fit my needs.
I added more mounting holes and closed the top. The hole for the antenna was a bit to big, so I shrinked that as well.
The back part was also modified to have a more “aerodynamic” look.

Happy printing :)

Comment & Rating (12)

Please fill in your opinion
(0/5000)

Had to do some scaling to get it right
The designer has replied
0
Reply
Hey :) how so? I’ve printed several canopies with this profile and I get it accurate all the time. maybe try to calibrate your printer and check if something is being changed on the profile :)
0
Reply
Replying to @Mayday :
I used identical settings. The first time it was too small, then it was too big at 104 and 102%. In the end 101% worked pretty well. I was printing in PETG which oozes a bit so I might try again in PLA when I break this one. I needed a lot of supports as well due to the only working orientation being upright.
0
Reply
Replying to @Crashandburn001 :
I just saw that you are printing in TPU!!! That makes sense, the added flex would make it easier to get on the drone. I don't have any TPU unfortunately (filament dryers are way too pricey). The printer is pretty much brand new though.
1
Reply
DO NOT PRINT IN PETG or PLA!!! Canopy shattered in a hard crash and snapped camera wires, out $50. Definetely TPU only or stay with the OG
The designer has replied
1
Reply
The profile was created using TPU. idk why people keep printing this with other material than TPU 😅 no pilot should print drone stuff with PLA/PETG. It’s just not the right use case for those materials.
0
Reply
Replying to @Mayday :
I now (after spending $80 repairing the drone) agree
0
Reply
if you can, could you make a version for the a1 mini? please and thanks!
The designer has replied
0
Reply
Sure ^^ I’ll try to get it done this weekend
0
Reply
Cool design. Thanks.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more