AirTag Carabiner with Threaded Cap
AirTag Carabiner with Threaded Cap
Boost
38
80
14
Print Profile(2)
0.2mm layer, 2 walls, 15% infill, PLA
Designer
35 min
1 plate
PETG Strong 0.16mm layer, 4 walls, 15% infill Gyro
50 min
1 plate
Open in Bambu Studio
Boost
38
80
14
2
145
149
Released
Description
Check out everything else I've 3D printed here https://www.samhillier.co/3d-print/
Lots of stuff I've not uploaded on here yet.
Check out my other designs!
Comment & Rating (14)
All
Print Profile
PETG Strong 0.16mm layer, 4 walls, 15% infill Gyro
No issues with the print. Threads work great. There is a watermark on the part which cheapens the look. When you tighten down the threads, they do not clamp the AirTag, which causes it to rattle.
0
Reply
Boosted
Great gift!
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
profile worked great with PLA on the A1 mini, I did have to slow it down a bit with petg.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
very nice design works perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
didn’t print very cleanly. part is to thick and broke when trying to separate carabiner part.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
The clip is way too loose. hinge should be slightly stronger. I printed with ABS 0.4 nossle and 0.8 height.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
Printed great. I would like it a little more if there was a taper on the clip end. Overall. a great print.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PLA
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld