Skadis Paper Clip / Letter Clip by chilman408

chilman408

Household>Office

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 18% infill

Designer

45 min

1 plate

4.8(8)

Open in Bambu Studio

Boost

122

126

Released

Description

I find that our local Ikea is alway out-of-stock on their paper clip for the Skadis board…

I created this paper clip (or letter clip) for the Ikea Skadis Pegboard system because I found other ones that are available on makerworld or other websites to be unreliable.

This is a 2-piece system. It is a bit longer and thicker than other designs but it will be much more sturdier and more reliable.

ASSEMBLY Instructions

Print the 2 parts.
Keep the 2 parts sseparate, mount the hook piece UP-SIDE-DOWN onto the Skadis board.
Press the top nob of the mounted hook piece down to lift the bottom tip up.
With the bottom tip of the hook piece lifted, slide the clip body onto the hook.

Comment & Rating (14)

@Wick3D_

Print Profile

0.16mm layer, 2 walls, 18% infill

Realy tricky... but it works now. Thank you. /// original Rating: Doesn't fit to my Skadis board. Tried mutiple times to Install. Finally a part broke while pressing into the board. I will give it a new try. Print works well! Thanks for sharing.

(Edited)

The designer has replied

@chilman408

You can't put the clip body on first. Put the hook onto the Skadis board first then slip the body on.

(Edited)

@MaNoe

It is perfect!

@moegelich

Print Profile

0.16mm layer, 2 walls, 18% infill

works like intended but a bit hard to get into the board

(Edited)

@user_3418832308

Print Profile

0.16mm layer, 2 walls, 18% infill

@OceanLabs

Carefully twisting the top sideways after the bottom is hooked in helps.

@alexxfloo

yesss

@gjmvhbvm2m

Boosted

Great design! A little tricky at first to understand how to slide the connection piece onto the board, but once you clue in then it's a perfect fit. Very nicely done