This is a hand fan for those moments when you need your colors and design. I used PLA for this one. However, PETG will make it more durable.

You will need to print 27 fan pieces and put them together with 1 small tube.

Put the tube in the fan hole and add the fan sheets.

Once they are together, you will need to use a torch to torch the end of the piece. Be careful not to melt the fan piece.

For the top part with the fabric:

Once you put the fan together, you will need to open the fan. With the fan open, take a piece of fabric, mark the fabric forming the fan arc, and cut it.

Use fabric glue to glue the fabric to one side of the fan (the front side). The long pieces at the top should be facing the back. At the beginning and the end glue the fabric around the piece.