INFILL JENGA WITH GAME DICE

I would like to introduce my project, INFILL JENGA with Game Dice.

You can play it with two game rules, classic one and with Specially crafted Game Dice.

Classic Jenga Rules

A Infill Jenga game consists of 48 precision-crafted, specially printed infill blocks.

To set up the game Stack all of the blocks in levels of three placed next to each other along their long sides and at a right angle to the previous level. Once the tower is built, the person who stacked the tower plays first.

Moving in the game Jenga consists of:

1) Taking one block on a turn from any level of the tower (except the one below an incomplete top level), and placing it on the topmost level in order to complete it.

Players may use only one hand at a time; either hand may be used, but only one hand may touch the tower at any time.

Players may tap a block to find a loose one. Any blocks moved but not played should be replaced, unless doing so would make the tower fall. The turn ends when the next player touches the tower, or after ten seconds, whichever occurs first.

The game ends when the tower falls -- completely or if any block falls from the tower (other than the block a player moves on a turn). 
The loser is the person who made the tower fall (i.e., whose turn it was when the tower fell).

Game Dice Version

Use Classic jenga rules with a TWIST!

In beginning of each turn roll a colour dice and you must pick only a colour that is on the top.

Printing instructions:

At first please make sure your print plate is CLEAN to maintain adhesion, best to wash it with dishwashing liquid and warm water, dry it and mount back.

1. Main print profile fits all bambu printers, consists of three plates with 16 Infill Blocks each, please print each plate with a different colour.
2. The Dice is printed by object, do not need AMS but helps a lot. Please use colours that pass your Jenga Blocks. Side plates will fit into the holes, in case any plate falls when throwing please use a drop of CA glue into the pin hole.