I have designed this fuse holder to take MIDI sized fuses.

I print these in 100% infill, 3 walls, 0.4mm nozzle, works great in eSun ABS+ filament

Parts needed to complete the build are as follows;

(all parts can be either BZP or stainless steel)

2 off M5 x 18mm BZP set screw

4 off M5 plain nut

4 off M5 flat washer

2 off M5 locking washer

2 off 3mm pan head screws to fasten it down. (length dependent on situation)

To assemble, push one set screw (each side) from underneath, then add one nut and tighten. Place one washer on top of this nut, then the ring terminal of the cable, then the fuse, washer, locking washer and lastly a nut. Don't over tighten the nuts.