Duplo to Hot Wheels Hinge Adapter + BETA Connector
Copyright Claim
Duplo to Hot Wheels Hinge Adapter + BETA Connector
Boost
20
51
10
Print Profile(2)
0.2mm layer, 3 walls, 25% infill
Designer
56 min
1 plate
BETA - Trackholder with Connector - 0.2mm layer, 2 walls
Designer
38 min
1 plate
Open in Bambu Studio
Boost
20
51
10
3
34
36
Released
Description
Update 28.04.2024:
As requested by a user, i added the first BETA version of the trackholder with connector. Due to the support, the surface is unfortunately not 100% beautiful, but the function is given. The surface can be seen in the picture. I will try a bit more with the custom supports.
The BETA trackholder can be printed separately using the custom print profile. Support is already included in the model and must be removed after printing.
---
This model is used to connect Hot Wheels rails to Duplo stones. For this purpose, the Duplo hinge was copied and the adapter redesigned. So the adapter can be used alone with the original Duplo hinge or with the one offered here.
Have fun with the reprint.
Comment & Rating (10)
All
Boosted
Print Profile
0.2mm layer, 3 walls, 25% infill
Cool design! But I think woulb even nicer if it had pin to work as connector. :)
The designer has replied
1
Reply
Thank you very much. Thanks for the tip, I'll see how I can implement this. It might be a bit difficult, as this side is currently resting on the print bed. I'm going to do a bit of tinkering.
0
Reply
Boosted
Replying to @Timbo_McFly
:)
0
Reply
Replying to @dreamer
Please check the new BETA Version of my Trackholder with connector! :)
(Edited)1
Reply
Boosted
thanks!
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 25% infill
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld