Volvo V40 Gen I - Wallart

Copyright Claim

Volvo V40 Gen I - Wallart

Boost
2
3
0

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.28mm layer, 4 walls
0.28mm layer, 4 walls
Designer
29 min
1 plate

Boost
2
3
0
0
6
3
Released

Description

A friend wanted his v40 as a bit of wall art and found a fully metal one which was quite an expensive and large item, with very little 3d modelling knowledge and eager to learn I've managed to trace it out and size it to fit on a single bed making it 29cm in length, I've only extruded a few mm as it is relatively small, any thicker and I reckon you'd lose some definition at angles but if requested I can add a thicker one.

 

There are no mounting points as it is very light and it can be held up with some double sided tape or a few bits of blutack to make it stand away from the wall slightly and give a shadow.

 

I'm working on making it bigger, over two beds and 3, but stuck figuring out how you would piece it together which is proving problematic.

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.