Tumbler Lid Organizer
Copyright Claim
Tumbler Lid Organizer
Boost
63
149
18
Print Profile(2)
0.3mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
0.3mm layer, 2 walls, 10% infill
1.6 h
1 plate
Boost
63
149
18
0
105
110
Released
Comment & Rating (18)
All
Print Profile
0.3mm layer, 2 walls, 15% infill
Printed great. Using tricolor silk PLA, i notice a distinct color shift inside. Would print again
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
slightly too small for my two largest lids (yeti iirc), but more than adequate for mason jar lids!
(Edited)
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
Love this. I have one in my cabinet for all my lids
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
scaled this up 10% to fit all my lids came out great!!
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
nice print just doesn’t fit all the lids I have so I printed it bigger.
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.3mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld