Easter Egg Bunny Ears Suprise
Copyright Claim
Easter Egg Bunny Ears Suprise
Boost
37
65
21
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
44 min
1 plate
0.2mm layer, 2 walls, 15% infill
59 min
1 plate
Boost
37
65
21
0
127
154
Released
Description
Hey there! Hunting for a super cute and festive Easter treat? This Easter Egg Bunny Ear is an absolute must-have for the upcoming holiday celebrations. This delightful bunny-shaped creation is can be filled with all the goodness of a traditional Kinder Egg, making it a sweet surprise for both kids and adults alike. Perfect for adding a touch of whimsy to your Easter festivities, this adorable treat is sure to bring joy and excitement to your egg hunt.
- No supports Needed.
- Happy with the print? I would love some feedback.
Comment & Rating (21)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Pla mate lilla bambu Lab
1
Reply
I printed it on the structured PEI plate and there was always a hole at the bottom. Printed on the X1C with Bambu yellow filament. Do you know why this happens?
The designer has replied
1
Reply
That is normal, I made it that way so a small cocktail pick can fit and you can stick it easier in the ground/a pot.
0
Reply
Replying to @Mvp3D.
alright, thanks for the answer. But sometimes the hole was very large (about 1,5 cm), sometimes it was smaller (maybe 1 cm)
(Edited)1
Reply
Replying to @Heimwerkerbienc
uhm oke, thanks for letting me know I will look into it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed flawlessly on the A1 Mini
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I updated the profile for a better right ear.
A bit fragile, but nice
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfekt
1
Reply
Would i be able to sell this model?
The designer has replied
0
Reply
sure, if you do it online please just give credit. good luck!
0
Reply
its a nice print but the ear need more attention
The designer has replied
0
Reply
thank you for the feedback!
I did notice a little problem on the right ear will fix it asap.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld