"Mind"
If you like to scale, do it only with x and y axis, do not change z axis!
Print at 100% infill with a layer height of 0.08mm and a base layer of 0.16mm
Wallgenerator is set to “Arachne” for better results, if your CPU is slow, change it to "Classic"
For better results you can use a 0.2mm noozle, just leave all other settings as they are.
Filaments Used:
PETG BambuLab Basic Black Transmission Distance: 0.3
PETG BambuLab Basic Blue Transmission Distance: 2.5
PETG BambuLab Basic Yellow Transmission Distance: 6.0
PETG BambuLab Basic Nature Transmission Distance: 8.0
You can use PETG BambuLab Basic RED Transmission Distance: 2.5 instead of Blue for warmer colors.
Swap Instructions: if you don't have ams just put pause on specified layers and swap filament manually
Start with Black
At layer #10 (0.88mm) swap to Blue
At layer #12 (1.04mm) swap to Yellow
At layer #16 (1.36mm) swap to Nature for the rest.
If you wanna use PLA:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Matte Marine Blue Transmission Distance: 2.0
PLA BambuLab Basic Yellow Transmission Distance: 6.0
PLA BambuLab Basic Beige Transmission Distance: 8.0
Just leave all other settings as they are.
I wish you always a clean nozzle!