A stand I designed for my turntable to allow it to hold up products vertically, such as my wall art plaques I make.
It should fit any turntable with a diameter at or bigger than 135mm.
This file contains both .stp and .stl formats.

V2:
- Changed the end peg height by 12mm. I had forgotten to test my other plaque on it and found it was too short.

Suggested Print Settings: (What my product pictures show)
- 0.4mm Nozzle
- 0.20mm Layer Height
- 30% Infill
- I set my slice to auto tree suppot and it put supports under the crest and underneath the front limbs, long with the curve of the limbs at the front

Turnaround: https://youtube.com/shorts/CJuJf96AdRk

>DO NOT resell/sell it by itself
>DO NOT redistribute this asset freely, please simply redirect them to this page

>DO credit me if you use it