This is a fully 3D printable clamped under desk drawer.

What makes this drawer different? Well, Because it's clamped, you don't need to ruin the bottom of your desk with screw holes!
Or is your work bench perhaps made out of STEEL? No screws, No problem!

Print Settings

• Notes:

The parts in the pictures were printed in PLA with a layer height of 0,4 mm.

No rafts or supports are needed.
(Except if you use the top pieces without the side supports or the longer drawers, then they might need some supports if your print bed isn't sticky enough, because the parts are quite slanted)

Post-Printing

To assemble, screw the top clamp on your desk, then slide the drawer in, and screw the back piece in. Done!

If you printed the print in place version, the the only thing you need to do is screw the clamp on your desk!