Just to be sure, did you have the plate you were using selected in the slicer? Not knocking you, I had no issue using the textured plate, twice. Thanks for the feedback. I'll print it again to see if there is an issue.
Yep, freshly cleaned (IPA/Paper Towels) Gold sheet. I'll give it another go, just had me scratching my head. I think I used the same filament both times, so there may be the issue. I'll test another one and will update my rating if I can complete it.
So I tried it again, failed (Photo attached).
Seems as though it's something to do with the supports printing on my X1C. Using the Standard .20mm Strength profile, using Bambu PLA Matte Grey.
However, I'm trying to print it again, minus the print profile, but following most of the settings (using hybrid tree supports vs the slim standard supports, as it eliminates the portion of the supports on the build plate that were having a problem).
Will report back once I have a result.