DUNE Poster / HueForge by TheProb

TheProb

Generative 3D Model>Hueforge & Lithophane

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 1 walls, 100% infill

Designer

1.9 h

1 plate

5.0(6)

Open in Bambu Studio

Boost

Released

Description

In the profile, the yellow is set with BambuLab PLA but I've used the below-mentioned Eryone one. Overall shouldn't be a mentionable difference between the two, just keep in mind.

Printing Instructions:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.28mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Matte Scarlet Red Transmission Distance: 2
    PLA Eryone HyperSpeed Yellow Transmission Distance: 14
    PLA BambuLab Matte Ivory White Transmission Distance: 4

Swap Instructions:
    Start with Black
    At layer #6 (0.68mm) swap to Scarlet Red
    At layer #12 (1.16mm) swap to Yellow
    At layer #19 (1.72mm) swap to Ivory White for the rest.

If you are satisfied with my design, I would be delighted if you could support me!

Comment & Rating (9)

@ParzivalIOI

super propre , j'adore excellent profil d'impression

@keribin.yoann

Print Profile

0.08mm layer, 1 walls, 100% infill

really cool and awesome 👍🏻

@user_2798146241

so cool!!

@yury.saakov

Print Profile

0.08mm layer, 1 walls, 100% infill

Nice!

@DanielWinter200

Print Profile

0.08mm layer, 1 walls, 100% infill

It's not exactly what is shown in the picture. Because you are swapping from black to red too early in the file. But it looks great anyway! I changed my rating, because you fixed it. Thanks!

(Edited)

The designer has replied

@TheProb

Thanks for the feedback, there was truly a mistake on the red swap. I've fixed and reuploaded the profile. It was pointless to create a new printing profile for this... Please remove it.

(Edited)