A simple stand for your TickrMeter so that you don't scratch the charging pins.

Printing

Just print it as is with a layer height of 0.2. Your printer doesn't need to be insanely calibrated to print this models, since the actual base has tolerances build in (aka. the base is slightly too big), so 0.32 should also work just fine.

How I Designed This

I've used Shapr3D to complete build this model from scratch and contacted Markus to get the correct measurements for the pin holes and their distance. The holes are slightly bigger than needed for tolerance.

I've included the 3MF files if someone else wants to perfect/change this design.