found a cool picture of a moh that had human skull for wings.. ran it through Hur Forge and added some red tones to spice it up a bit

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

REMEMBER: you can change X and Y axis to suit your needs but don't mess with Z axis or your swaps will be off…

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Gray
At layer #17 (1.44mm) swap to Red
At layer #25 (2.08mm) swap to Silver
At layer #30 (2.48mm) swap to White for the rest.