Summary

This is a tiltable stand/holder for the tinySA ULTRA spectrum analyzer. The tinySA ULTRA is a very nice spectrum analyzer but is designed to lay flat. This stand allows you to tilt it to make it easier to use on the bench. It tilts from vertical to laying flat, and everywhere in between. The tinySA ULTRA is held securely but slides out easily from the top of the holder.
A cutout in the bottom of the holder allows you to have the USB or phono jack connected while in the stand (needs to be tilted slightly when a cable is used). There is also a holder for a stylus, used to control the touchscreen.
There are 3 files: the main holder body, the base, and a stylus.

EDIT (6/19/2024): The holder and base are connected with a ¼" 1" bolt and hex nut.

Print Settings

Printer Brand: 

Creality

Printer:                      

Ender-3 S1 Pro

Filament:

Hatchbox PLA                Black                    
                        

Notes:                     

The Holder:  I printed it at 0.12mm but 0.2 should be fine also.  I printed this with supports under the pivot's bottom curve and in the pivot hole but it would probably be fine with no supports.

The Base: I printed it at 0.12 but 0.2 should be fine also. Printed with supports (for the holes in the pivot).

The Stylus: I printed it at 0.12. Printed with a raft and no supports. Used Adaptive Layers setting in Cura to make it smoother. You should sand the tips very slightly to make sure there is no burrs on the rounded tip.