Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Open in Bambu Studio
Boost
12
33
13
4
79
76
Released
Description
A simple small stand to hold the round hygrometer/temperature sensor.
I needed a stand to place the hygrometer in my bathroom to check if hummidity levels are ok.
The Hygrometer used is this one: https://www.amazon.de/dp/B07JG9QZ2B
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Rotated to print with face down on bed
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed with support
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect print and fit
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
They printed a little rough near the top of the holder, ha go at it with a debur tool to get the hydrometer to fit. Other than that it looks good!.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld