Compact Magnetic Bang! Card Game Holder
Compact Magnetic Bang! Card Game Holder
Print Profile(0)
Description
This is a compact holder for the card game Bang. It only fits the original game, without the bullets or legend cards. Two 10x2mm magnets are needed for this. Drop the magnets in just before the printer bridges the holes. If your printer has steel parts in the hotend use double sided tape to stick the magnets to the bottom of the holes so they don't stick to the hotend when it passes over it.
See the print settings for additional details.
I used these magnets: https://www.aliexpress.com/item/50pcs-Neodymium-magnet-10x2-Rare-Earth-small-Strong-Round-permanent-10-2-mm-fridge-Electromagnet-NdFeB/32890853468.html?spm=a2g0s.9042311.0.0.44064c4dd1Y3Rr
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.1-0.2
Infill:
10%
Filament:Spectrum PLA Volcano Grey
Notes:
Print upside-down, use 0.1mm layer height for the first 5mm.
Use supports for the underside of the hinges, 2 separation layers.
Big hole for the cards might need supports depending on your printer's bridging capabilities (I used them).
Comment & Rating (0)
License
