This is a 3D mesh/fabric/coaster that is very cool to feel in hand.

I used the Bambu Lab P1S and Esun PLA filament for this print and it prints beautifully, especially with the textured PEI plate.

-Print settings I used the standard Bambu studio settings for PLA

!!CAN BE PRINTED IN LUDICROUS MODE WITH NO ISSUES (on my end) if issues arise I found that you can raise the temperature slightly to fix flow

Note: When freshly printed you may need to play with it a bit to get it to loosen up. It should be quite fluid when you move it around. What I do is fold it and just go back and forth for a little while and do the same thing for the other end and it is all loosened up!

link to my Etsy Shop: https://www.etsy.com/shop/Your3DprintsUS?ref=shop-header-name&listing_id=1518717738