Since wooden panels are not sold separately, I wanted to make one.
It should be completed just by gluing with a thin board.
I think PLA is fine, but we recommend printing with a durable material such as ABS.
This is because PC cases are hermetically sealed and tend to trap heat.
I divided it into two so that it can be printed at a general 235x235.
A full size frame is also included.
The magnet part has a 4.5mm hole.
There are 3 types of depth. Use 3mm counterbores and through holes and M4 countersunk screws.
Models using M4 have not been tested.