Heart shaped wine bottle holder.
Boost
56
60
8
Print Profile(1)
OnePlate 0.2mm layer, 2 walls, 15% infill
7 h
1 plate
Boost
56
60
8
2
127
40
Released
Description
The printout consists of two parts. Heart print sheets to mat. Print the base on the side for better strength. The opening for the bottle is 80 mm.
Comment & Rating (8)
All
Print Profile
OnePlate 0.2mm layer, 2 walls, 15% infill
A bit to fragile, lost some small bits when it came of the bed. But goodlooking anyway 👍
0
Reply
Boosted
Print Profile
OnePlate 0.2mm layer, 2 walls, 15% infill
1
Reply
Boosted
The model is phenomenal. Well done! Keep on creating. I can't wait for your new ideas.
The designer has replied
1
Reply
Thank you very much for your kind comment
1
Reply
Boosted
Very good design
0
Reply
bel progetto. peccato non sia possibile usare la funzione dividi per poter stampare in multicolore senza dover usare lo stumento riempi di bambu studio( che come in questi casi fa più danni)
se riesci a modificare il progetto e dividere in parti lo stampero molto volentieri a colori
0
Reply
Print Profile
OnePlate 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
OnePlate 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld