Overview

This is a mount for a altoid tin to Ikea Skadis, which uses the T Nut System made by 6d6178 My skadis is mounted to my Raskog Cart, so I put these altoid-sized tins (from Adafruit) up on there to hold the bits for my LTT screwdriver.

T Nut Screw Specs

The T nut system uses M2 or M2.5 screws to mount to the IKEA SKÅDIS pegboard system.

I'm only including an M2.5 version here because to be honest, it is what I had on hand and don't think many people use the M2 version.

• The longest screw you can use is 24mm long ex. M2.5x24
• The shortest screw you can use is 12mm long ex. M2.5x12

I personally used these: https://www.mcmaster.com/91290A104/ but McMaster-Carr is expensive, so you could use Amazon if needed to find them.

You might have to use supports, depending on your printers overhang skills, etc. YMMV. Print the mount of + one of the T Nuts (M2.5) from here.

Terms

Your results obviously may vary.Please feel free to give feedback, it is most welcomed. Thanks and happy printing.

Updates

I will update this section as needed to give an overview of how progress is being made. It is my goal to constantly improve based off of peoples feedback.