This is a simple pixel art template to use with the AMS unit.

Print at 0.2mm base layer and 0.24mm layer height.

Paint it using the “fill/bucket brush” in bambu studio, and make sure you have the “fill angle" set to at least 60 so it cover the side of the pixel, not just the top surface.

Available in 4x6in and 5x7in.

It also measure less than 1mm in height, so the print time is just a little more than an hour (if you are using only 4 colors) and can be fit into most photo frame.

You might be able to create some interesting design if you have more than 1 AMS unit. It can also be a fun project for kids too, since it is easy to paint on.

The photo shows a finished artwork embed into wuguigui's photo frame (can be found in here: https://makerworld.com/en/models/12924#profileId-110758)