V8 Engine Cooler
Print Profile(1)
Description
After posing my V6 Engine Cooler, I had many people wanting a V8 Engine Block Cooler. This V8 cooler is sliced for P1 and X1 printers sonly. I labeled the plates for easy orientation during install and print. The duel color is set after slicing and I placed a color change in the file so it saves time in print and same across the board once you assemble. Change the color combo to your preference.
Support is needed
I only use support interface on the top lid. The rest was not needed and it saved time.
Note: because I sliced it to build the cooler, I used a Gorilla rubber type glue to seal all the seams so it wont leak when you put Ice in it. Due to the very tight tolerance of the lid, I pre-shrunk it to 99.8 percent so its easier to put the lid on. For some reason it shows up as 100% after doing this, so if you want to put it back to original size, just put it 100.02% but it will be very tight.
My V6 Version: https://makerworld.com/en/models/211857#profileId-231643
Koozie: https://makerworld.com/en/models/411911#profileId-313818
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (34)