Was making a “Brick” table for my son and though, 10$ a pop for plates? No way!

So this is just a VERY simple version. It works very well using the .3mf provided for the X1c.

If you do not wish to use the .3mf i recommend the following settings:

Material : I just use PLA, PETG could be good, real “bricks” are made from ABS, I don't care for the smell so i'm sticking with PLA.

0.4mm nozzle
0.16mm optimal # BBL X1C
Line width

• Default : 0.41
• Outer Wall : 0.41
• Top Surface : 0.41
• Internal solid infill : 0.41

Top Surface pattern : Concentric

Top shell layers : 3

Bottom surface pattern : Rectilinear

Sparse infill density : 25

Sparse infill pattern : Gyroid

As far as speed:

Initial layer : 40

Initial layer infill : 95

Last but not least, bed adhesion

Brim type : Outer brim only

Brim width : 7mm

Now you can play around with the infill, i went down to 5% which I used for my purpose (a glued on wood plate). I wouldn't recommend it for playable plates as it makes them too brittle and .. well lets face it, our “young ones” are not exactly delicate yet!

Hope you guys like it. I plan on releasing another version that would be evenr better for glue adhesion.