Car vacuum tip for side of seats NOW WITH WIDER TIP TOO
Copyright Claim
Car vacuum tip for side of seats NOW WITH WIDER TIP TOO
Boost
4
10
4
Print Profile(2)
0.25mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
WIDER tip 0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
4
10
4
0
13
12
Released
Description
ever wanted to clean the sides of your car seats ? yea you know that black hole almost… this is your answer for it it picks up most small rocks that might get there from going in and out of your car , or it doesnt have to be for your car it can be for around the house as its a 17cm long tip and fits a 35.7 mm diameter vacuum hose, the current setting on it is set to have 35.9mm inner diameter so it can slide onto the hose nice and tight.
NO SUPPORT REQUIRED!
Comment & Rating (4)
All
Print Profile
WIDER tip 0.2mm layer, 2 walls, 15% infill
To thin in PLA, Worked ok in ABS but the layers make the print a bit to weak for my usage in cars etc. with PLA. Had been perfect if it were a bit thicker.
The designer has replied
1
Reply
thats odd that it was to thin in pla as mine was also made with it but workes fine . hmm ill make a thicker version or adjust the print profile to have more walls and a bit more infill . fhank you for saying that though!
0
Reply
Print Profile
0.25mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.25mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld