Voronoi IKEA SKADIS box

Remixed by
Copyright Claim

Voronoi IKEA SKADIS box

Remixed by
Boost
96
323
20

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 4 walls, 25% infill
0.2mm layer, 4 walls, 25% infill
Designer
2.3 h
1 plate
4.3(15)

Open in Bambu Studio
Boost
96
323
20
7
244
161
Released

Description

This is a remix of CarlDon's Remix of Gridfinity Voronoi Bin for IKEA Skadis Pegboards https://www.printables.com/model/752993-remix-of-gridfinity-voronoi-bin-for-ikea-skadis-pe/files which is a remix of Max's Gridfinity Voronoi bins all sizes https://www.printables.com/model/716015-gridfinity-voronoi-bins-all-sizes.

 

The model still included the Gridfinity bases which are unnecessary and waste filament. I lowered it into the plate to eliminate these - it's at 23.97mm Z height if you're slicing this yourself. It still leaves 4 layers for the base.

 

I made sure to provide supports under the pegs, regular supports because I had the rear tree support detach. I blocked supports everywhere else, otherwise there would be a lot of supports. The bridges and overhangs do OK without them, not perfect but nothing a few strokes with a hobby knife won't fix.

 

Printed it with 4 walls for strength because that's all this model has! I used 25% gyroid infill but this doesn't matter much, there's hardly any infill in this model. Printed in JAYO PLA+ white.

 

Prints well. Decorative and functional.

 

Comment & Rating (20)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 4 walls, 25% infill
Printed in Sunlu white PLA on a P1S, perfect fit for my cleansing towels ;)
The designer has replied
1
Reply
Excellent!
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
printed prefect.
The designer has replied
1
Reply
Looks great!
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
The designer has replied
1
Reply
Looks good!
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
failed. Print canceled
Show original
0
Reply
impression annulée car tout c'est cassé
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
printed ok on PETG, one leg failed to print tho
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
Strength Issue:I think this may be better with some tweaking but the hooks on the back cracked when I went to slot it into the board.
Support Issue:could be the silk PLA I used by anycubic but overhangs failed on some of the wall patterns.
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
looks lovely, my pla let it down as it was moist
1
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
works great
1
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
Breaks immediately
Show original
0
Reply