Swiss key holder 2.0
Copyright Claim
Swiss key holder 2.0
Boost
38
63
10
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
59 min
1 plate
0.2mm layer, 2 walls, 15% infill
28 min
1 plate
Boost
38
63
10
0
101
55
Released
Description
My previous version (v1.0) of key hoder was alright, but had some design flaws and mainly, since then, I discovered the allmighty threaded inserts. So the goal was clear - make the model from scratch, more design consistent and get rid of the nuts. The result is Swiss key holder 2.0
Print instructions
- Printed in PLA, but any material should do
- No supports needed
- 3MF and gcode are double color
- 30% infill
- 3 perimeters
- Ironing recommended
Additional hardware needed
- 2x M3 threaded insert
- 2x M3 screw 10-20mm (depends on number of keys (M3x16 for 8 keys))
Comment & Rating (10)
All
Printed well in single color PLA
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed great, used m3 inserts, thanks!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Merci pour le partage
0
Reply
Printed with PC on my X1C
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
It would be great to have the same settings in the profile, as mentioned in the Model Description as suggestions.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
The print profile is no longer public
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld