Swiss key holder 2.0

Copyright Claim

Swiss key holder 2.0

Boost
67
126
24

Print Profile(2)

All
A1
P1P
P1S
X1
X1 Carbon
X1E

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
59 min
1 plate
4.6(18)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
28 min
1 plate
5.0(3)

Open in Bambu Studio
Boost
67
126
24
13
197
119
Released

Description

My previous version (v1.0) of key hoder was alright, but had some design flaws and mainly, since then, I discovered the allmighty threaded inserts. So the goal was clear - make the model from scratch, more design consistent and get rid of the nuts. The result is Swiss key holder 2.0

Print instructions

  • Printed in PLA, but any material should do
  • No supports needed
  • 3MF and gcode are double color
  • 30% infill
  • 3 perimeters
  • Ironing recommended

Additional hardware needed

  • 2x M3 threaded insert
  • 2x M3 screw 10-20mm (depends on number of keys (M3x16 for 8 keys))

Comment & Rating (24)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Printed with no issues
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
The print came out very well however I had some issues with the threaded inserts. The holes did not fit the M3x4x5 inserts, which were the smallest m3 inserts I had, so I had to modify the model a little to fit them.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Funktioniert sehr gut.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Very nice key organiser
0
Reply
Printed well in single color PLA
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed great, used m3 inserts, thanks!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Merci pour le partage
0
Reply
Printed with PC on my X1C
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Print came out perfect. However I am going to modify it and drill a third hole in the middle and pass through another screw. So that the keys only come out to one side.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I've been using this as my daily keychain for a few months with no problems and lots of compliments.
0
Reply