Print Profile(2)
0.2mm layer, 3 walls, 20% infill
Designer
2.1 h
1 plate
Voronoi Bracelet - 90% model size 0.2mm layer, 2 walls, 15% infill
1.6 h
1 plate
Open in Bambu Studio
Boost
14
30
12
0
37
22
Released
Description
This model is a little oversized but can be scaled in the slicer to accommodate different hand/wrists sizes.
I printed it with a 5mm brim and 0.2mm layer height. No supports needed. dropping the model down on the Z-axis about 0.2mm will help with bed adhesion by creating more surface area contact.
Comment & Rating (12)
All
Print Profile
Voronoi Bracelet - 90% model size 0.2mm layer, 2 walls, 15% infill
I try with PLA and TPU. Just TPU was better, but any points was't completed. I don't know why, but Shit!
The designer has replied
0
Reply
I'm not the designer I just uploaded the print profile. Thanks for giving it a go. Sorry it didn’t work out for you. The profile printed well for me and judging on the other feedback it seems to have worked well for others as well.
(Edited)0
Reply
Print Profile
Voronoi Bracelet - 90% model size 0.2mm layer, 2 walls, 15% infill
simple and Great impact!
The designer has replied
0
Reply
I'm not the designer I just uploaded the print profile. Thanks for giving it a go and thanks for rating. Glad you liked it.
(Edited)0
Reply
Print Profile
Voronoi Bracelet - 90% model size 0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for giving the profile a go and thanks for rating.
0
Reply
Print Profile
Voronoi Bracelet - 90% model size 0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
I'm not the designer I just uploaded the print profile. Thanks for giving the profile a go and thanks for rating it. Glad you liked it.
0
Reply
Print Profile
Voronoi Bracelet - 90% model size 0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
I'm not the designer I just uploaded the print profile. Thanks for giving it a go and thanks for rating. Glad you liked it.
(Edited)0
Reply
Print Profile
Voronoi Bracelet - 90% model size 0.2mm layer, 2 walls, 15% infill
Strength Issue:Printed great! Beautiful design. However, it can be broken and torn apart with minimal force. At the current strength and print settings I wouldn’t recommend for daily wear, only to test for fit.
The designer has replied
0
Reply
I'm not the designer I just uploaded the print profile. Thanks for giving it a go and thanks for rating. Sorry the end result didn’t meet your expectations in terms of strength.
(Edited)0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld