Fishing Rod Holder Small V2
Copyright Claim
Fishing Rod Holder Small V2
Boost
10
33
5
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
10
33
5
1
62
54
Released
Description
Updated based on comments. Simple fishing rod holder if you don't like your rod sections banging around in the storage. This one should fit most small, light rods.
WARNING! Be very gentle when you use this with the top section of a light rod. this section is very fragile! you mostly want to slide up and down the holder instead of just pushing and pulling it on the rod! Be warn!! :)
Comment & Rating (5)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Look ok from the top, but need fixing with the heat gun due to the filleted edge and unformed "T", which leads to first layer issues.
The designer has replied
0
Reply
Thank you for the feedback @Rick269 ! I modified the models to arrange the small problems you mentioned. Updated all three.
0
Reply
Replying to @plucbernier
Good job, they will work fine anyway.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld