Fishing Rod Holder Medium V2
Copyright Claim
Fishing Rod Holder Medium V2
Boost
14
26
7
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
18 min
1 plate
Open in Bambu Studio
Boost
14
26
7
0
56
55
Released
Description
Updated based on comments. Simple fishing rod holder if you don't like your rod sections banging around in the storage. This one should fit most medium power rods.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Still has the issue with the first layer with the filleted edge and a letter "T" embedded into the bottom.
The designer has replied
0
Reply
Thank you for the feedback @Rick269 ! I modified the models to arrange the small problems you mentioned. Updated all three.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
works well and came out fine. thx for sharing
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
works perfectly
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld