GALAXYS EDGE AMAZON FIRE 7-8 TABLET HUD DISPLAY PLATE

Thank you for Downloading my models and for your support.

Amazon Fire 7-8Table HUD display Plate inspired by Galaxies Edge wall Panel
This can be printed using a single-color PLA

The panel was design to be use horizonal or vertically and had to sliding mounting brackets to help hold the weight.

On the back side of the model, you will find an open area that can be used to install over a to run the power cable down into a junction box or electrical outlet.

3D PRINTING SETTINGS

Print Settings
0.2mm layer
2 walls
15% infill
Ironing on top surfaces for a smooth finish
add supports for the bottom of the plate
For best results use Ironing on all top surfaces

INSTALLATION

Insert Amazon Fire Tablet from the right side opening on the wall plate. Amazon Fire 7 might be a bit loose this can be adjusted by adding a small amount of foam tape.  Amazon Fire Tablet 8 Fits Perfectly snug.  

Panel can be installed in the vertical or horizontal orientation

There a two slide brackets on the back of the plate. This is required to make the panel stable once installed in the wall. Use a standard wall screw to mount this.