Tape Holder for Honeycomb-wall
Remixed by
Copyright Claim
Tape Holder for Honeycomb-wall
Remixed by
Boost
24
96
13
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
25 min
1 plate
Boost
24
96
13
0
90
63
Released
Description
Use at least 3 walls to get proper strength. You need support no matter what stance you print this. Tape does not give much weight to this holder, so you might want to print this vertically to minimize filament needed for supports.
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Print in ABS
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
all perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
excellent for tape
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Leider zu locker fällt immer wieder raus
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:beim vorsichtigen herauslösen bricht das Modell leider ab
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld